Hey guys posted up a while ago about a carby spacer on a 253 with an elderbrock performer ect ect
this times its a 2inch super sucker on an original stripmaster running a 650e85 quick fuel carb.
i gotta run her up on the dyno this week wat do people think run her up with the carb spacer this time as we have gone to single plane or take it off
im running inch5/8 pipes this time as well ill post the specs up of motor just will put the link below to my current thread.
http://www.aussiev8.com.au/holden-v8...253-could.html if ya could let me know wat you think would be good ...
If not in the end i might have ta try back to back runs with on/off.
this times its a 2inch super sucker on an original stripmaster running a 650e85 quick fuel carb.
i gotta run her up on the dyno this week wat do people think run her up with the carb spacer this time as we have gone to single plane or take it off
im running inch5/8 pipes this time as well ill post the specs up of motor just will put the link below to my current thread.
http://www.aussiev8.com.au/holden-v8...253-could.html if ya could let me know wat you think would be good ...
If not in the end i might have ta try back to back runs with on/off.