Hey guys,
I just bought a 350 vortec motor off ebay for $750
It's done 200 hours, marine engine and spun a bearing, no damage to the block, crank needs a regrind and rod needs a hone, but I'm just going to get a 383 stroker kit to put in it. pistons are 20 tho currently but can't find a 20 thou piston stroker kit, so i'll probably have to get it bored to 30 thou.
Does anyone know a good place to get the bottom end ready, and maybe how much I'd be looking at for the work?
This will be my first engine build so i'm not sure what i'm doing, but i'm assuming the block will need to be crack checked, possibly acid dipped, and then bored to 30thou and bottom end assembled...
Anyone got any ideas what sort of cash i'd be looking at or what i should do?
I just bought a 350 vortec motor off ebay for $750
It's done 200 hours, marine engine and spun a bearing, no damage to the block, crank needs a regrind and rod needs a hone, but I'm just going to get a 383 stroker kit to put in it. pistons are 20 tho currently but can't find a 20 thou piston stroker kit, so i'll probably have to get it bored to 30 thou.
Does anyone know a good place to get the bottom end ready, and maybe how much I'd be looking at for the work?
This will be my first engine build so i'm not sure what i'm doing, but i'm assuming the block will need to be crack checked, possibly acid dipped, and then bored to 30thou and bottom end assembled...
Anyone got any ideas what sort of cash i'd be looking at or what i should do?