I'm going to do head gaskets ,arp studs ,cam and valve springs on my t04z 304 .
Now I picked up a new set of cometic MLS gaskets cheap as on eBay without really knowing what I was talking about anyway they are 60 thou thick to suit 4.1 inch bore would these lower compression to much I've never had these heads of so I'm not sure of bore size???
Cam ,springs and any other mods I should do while I've got the engine out maybe other valve train mods I'm up for suggestions.Obviously I'll need heads machined to suit steel gaskets but what a bout the block?
I will build a decent bottom end at some stage but I don't think I've got the funds for full tear down right now I really just wanna pull 10psi safely
i have a blown head gasket now due to computer failure and my ignorance
Oh yeah it's in a hilux 4wd
Now I picked up a new set of cometic MLS gaskets cheap as on eBay without really knowing what I was talking about anyway they are 60 thou thick to suit 4.1 inch bore would these lower compression to much I've never had these heads of so I'm not sure of bore size???
Cam ,springs and any other mods I should do while I've got the engine out maybe other valve train mods I'm up for suggestions.Obviously I'll need heads machined to suit steel gaskets but what a bout the block?
I will build a decent bottom end at some stage but I don't think I've got the funds for full tear down right now I really just wanna pull 10psi safely
i have a blown head gasket now due to computer failure and my ignorance
Oh yeah it's in a hilux 4wd