about to start to assemble a 55 for a customer ,this is going into a vk brock
specs are 355
11 to 1 comp
scatt crank
i beam rods
srp professional pistons
file fit rings
custom hydro roller cam
crane premium roller lifters
trend push rods
farea comp plus valves
pac springs
ported vn heads
ported harrop single plain intake
msd dizzy
one of my killer carbs
high energy sump
one of my race spec oil pumps
the block has had my oiling mods done which are good for 7500 rpm not that this will go that far but just a precaution .
![]()
getting carried away with all the details
![]()
all the valley has been prepped
![]()
along with under the timing cover
![]()
underneath gets a good polish too
![]()
when we paint we mask everything ,just makes the job that bit nicer
![]()
and this is the block [heads are done the same way just ran out of memory space]ready to go into the assembly room for the next stage of the proccess,
zok
specs are 355
11 to 1 comp
scatt crank
i beam rods
srp professional pistons
file fit rings
custom hydro roller cam
crane premium roller lifters
trend push rods
farea comp plus valves
pac springs
ported vn heads
ported harrop single plain intake
msd dizzy
one of my killer carbs
high energy sump
one of my race spec oil pumps
the block has had my oiling mods done which are good for 7500 rpm not that this will go that far but just a precaution .
getting carried away with all the details
all the valley has been prepped
along with under the timing cover
underneath gets a good polish too
when we paint we mask everything ,just makes the job that bit nicer
and this is the block [heads are done the same way just ran out of memory space]ready to go into the assembly room for the next stage of the proccess,
zok