Hi all,
Im rebuilding my 304 to 355 stroker but before I send the motor away to get built, I want to clean the block as it has done 300,000+ k/m's and is in a really dirty state. Iv been looking up sand blasting or dry ice but not sure what's the best way. If anybody could recommend which way to do it, would be helpful.. And to add the block is completely strip, ready to go
Cheers
Im rebuilding my 304 to 355 stroker but before I send the motor away to get built, I want to clean the block as it has done 300,000+ k/m's and is in a really dirty state. Iv been looking up sand blasting or dry ice but not sure what's the best way. If anybody could recommend which way to do it, would be helpful.. And to add the block is completely strip, ready to go
Cheers