hey guys hows it goin, due to a unfortunate certumstance i hav not yet obtained my engine from war built. so without the engine i cnt fit my new turbo400 into my vk as i don't know where the crossmember will end up. and without the th400 in i cant measure my tailshaft...
my idea and im chasing advise on it is i hav a trimatic boltpattern block in the shed. if i throw that in my car then shov the transmission hard up against it, will tht be a gud enough indication as to where i have to mount the crossmember and will that be accurate enough to measure my tailshalft to be remade
i hav gone from a trimatic and oem diff to a turbo400 and shrt yoke ford 9inch
my idea and im chasing advise on it is i hav a trimatic boltpattern block in the shed. if i throw that in my car then shov the transmission hard up against it, will tht be a gud enough indication as to where i have to mount the crossmember and will that be accurate enough to measure my tailshalft to be remade
i hav gone from a trimatic and oem diff to a turbo400 and shrt yoke ford 9inch